High Specification FIDs

Superior Technical Support

Best Warranty



Model 3000HM, Heated Total Hydrocarbon Monitor with fully-implemented microprocessor control, heated flame ionization detector, internal sample pump and cayalytic combustion air generator. For Total Hydrocarbon Monitoring in accordance with 40 CFR Part 60 Method 25A. CE marked for safety and EMI protection. Non-methane and portable versions for your VOC monitoring application


VOC Analyzers



Heated Total Hydrocarbon Analyzer Model 3000HM

The Signal Instruments model 3000HM is a superior new totally-heated FID-based hydrocarbon analyzer. It has been designed from the ground up to be accurate, reliable and easily maintained. In operation, the instrument is safe, simple, quiet and highly stable. The 3000HM features a catalytic internal air supply and requires no external sources of zero gas or detector combustion air, sets up quickly and is designed for minimal power consumption.

Heated total hydrocarbon analyzer has a totally automatic microprocessor-based operation including: auto-ignition, auto-calibration, auto-range with ID and auto-purge on shutdown. This makes the instrument ideal as a "smart" stand-alone unit or as a "building block" for systems integration via a bi-directional RS-232 communications port. The instrument may be remotely controlled and monitored via serial communication, contact closures or TTL logic combinations.
Automatic diagnostics and fully-configurable alarms are also integral to the hydrocarbon analyzer. Simultaneous 0-10Vdc and isolated 4-20mA outputs are also standard.
A large multifunction, backlit LCD provides a clear display of hydrocarbon concentration measurement, range, sample flowrate and the status of critical operating parameters (oven, catalyst and flame temperatures, fuel, air and sample pressures, DC and bias power supplies). The intuitive, menu-driven interface and soft key buttons enable the operator to quickly configure and control the monitor's function. The unit features 19" rack mounting at 3 RU height and a weight of only 35 Lb. It has a dual voltage capability of 115 VAC and 230 VAC, selectable from the rear panel. CE marked.

Download the 3000HM Operating Manual
(Adobe PDF format 1.08 Mb)


Portable Heated Total Hydrocarbon Analyzer Model 3010 MiniFID

A 5 meter or 10 meter heat-traced sample line is included with the 3010P. Please specify the length when placing your order.

The model 3010P MiniFID is a self-contained, portable heated total hydrocarbon analyzer system with a built-in heated sample line controller and detachable bottle rack for fuel and calibration gas cylinders. Standard connections allow the use of full-sized gas cylinders for use in temporary continuous or extended operation. The 3010P MiniFID uses the same sample-handling and heated flame ionization detection components as the microprocessor-powered 3000HM Hydrocarbon Analyzer. Use of a current-matched low voltage control transformer and unique heated sample tubing design enable the 3010P to achieve a CE mark for safety.






Hydrocarbon analyzers for special applications are available. Call us with your application requirements.

[e-mail us for more information on our hydrocarbon analysis products]

[Site Map]

K2BW Environmental Equipment Co.
355 North York Rd.
Willow Grove, PA 19090
Tel: 215.830.8882
Fax: 215.830.8922
email: sales@k2bw.com
Hours of operation:
M-F 8AM to 6PM
weekends and 24-hour emergercy service by agreement
© 1996-2013 K2BW All Rights Reserved